| Chipset |
- Intel 82443BX AGPset, Supports 100MHz SDRAM
- Intel 82371EB (PIIX4E), Supports :
1. Independent timing of up to 4 drivers
2. PIO mode 4 transfers up to 14Mbytes/sec
3. Supports "Ultra 33" synchronous DMA mode transfers up
to 33Mbytes/Sec
4. Integrated 16x32 bit buffer for IDE burst transfers
|
| Bus Type |
- 2 PCI local bus slots.
- 1 ISA bus slot
|
| CPU |
- Intel Pentium II Processor 233/266/300/333/450 (66MHz)
- Intel Pentium III Processor 350/400/450/500/550(100MHz)
- Intel celeron processor up to 400MHz
- Intel celeron PPGA processor up to 533MHz(Convertor card
with voltage control needed for support)
|
| System Memory |
- Two 168pin 3.3V buffered/unbuffered 100MHz DIMM sockets
- Supports up to 256MB SDRAM memory (Register SDRAM up
to 512MB)
- 100MHz/66MHz synchronous DRAM (66MHz EDO DRAM)
- SDRAM 64 bit data interface with ECC support.
- 4/16/64/128/256Mbit DRAM device
|
| BIOS |
- Award Flash BIOS with PnP ready.
- Jumper emulation
|
| On board IDE |
- 2 PCI PIO and Bus Master IDE ports.
- Supports up to PIO mode 4, Ultra DMA 33
|
| On board AGP |
- ATI RAGE IIC (or Rage Pro) AGP graphics controller
- Integraded 3D, 2D and video accelerators with palette
DAC and quadruple clock synthesizer 2MB or 4MB SGRAM display
memory on-board
and a SO-DIMM for extension (optional)
- Use 8MB SGRAM maximum.
- Supports maximum resolution of 1600x1200 at 75Hz (Depending
on the memory configuration)
|
| On board audio |
- Creative CT2511 16bit sound chip
|
| I/O Feature |
- Winbond W83977 EF I/O chip.
- All I/O ports can be enabled/disabled by BIOS setup
- 1 Floppy port supports up to two 3.5" or 5.25" floppy
drivers (360K/720K/1.2M/1.44M/2.88M)
- Supports LS-120 floppy disk driver and ZIP drive
- 2 High speed 16550 fast compatible UARTs (COM1/COM2/COM3/COM4
selectable) with 16-byte send/receive FIFOs and supports
MIDI mode
- 1 Enabled parallel port (SPP/EPP/ECP) at I/O address
378H/278H/3BCH with additional bi-direction I/O capability
and multi-mode (SPP/EPP/ECP) (IEEE1248 compliant)
- Provides protection circuit to prevent damage to parallel
port when a connected printer is powered up or operated
at higher voltage
|
| Green Function |
- Full support of ACPI and OS Directed Power Management.
- Supports three green modes : Doze, Standby and Suspend
- Green LED will blink when the system is in green status
|
| Advanced Feature |
- On-board WB83782D system monitoring (monitors system
voltage, system temperature & temperature of CPU, chassis
intrusion and FAN speed)
- Supports keyboard password power-on.
- Support LDCM and ManageEasy (optional).
- Supports both internal and external modem ring power-on
- Supports wakeup on LAN.
- On-board PS/2 mouse and PS/2 keyboard socket.
- 2 USB ports
- On-board switching voltage regulator with VID (supports
1.3V to 3.5V).
- Anti-Virus function in BIOS and driver.
- Supports IrDA infrared
- Supports Windows 95/98's software power-down.
- Supports auto fan off when system enters suspend mode.
- Supports power failure resume function
|
| Board Size |
|
